Home > Latest News

Sort Article

Latest News

How to Evaluate the Performance of an Injection Molding Process?
Post：2023/01/07

The article – How to Evaluate the Performance of an Injection Molding Process? – written by Effinno

Light MES: No-Sensor-Box Industry 4.0 Machine Utilization and OEE Management System
Post：2023/01/07

Light MES requires no additional sensor-box-like device being installed on any machine to serve.

MeltFlipper Technology – Much More Than Mold Filling Balance
Post：2023/01/07

The MeltFlipper Technology, patented by Beaumont Technologies Inc., is the only solution that can

Integrated Weight Data Analysis of Injection Molding – August 24, 2021
Post：2023/01/07

Organized by PIDC (Plastics Industry Development Center) Taiwan, Effinno Technologies delivered the

Taguchi DOE, the Skill of Optimizing Injection Molding Condition – August 9, 2021
Post：2023/01/07

Organized by PIDC (Plastics Industry Development Center) Taiwan, Effinno Technologies delivered the

TEN PART-DESIGN RULES FOR GAS-ASSISTED INJECTION MOLDING PROCESS
Post：2023/01/07

The article - TEN PART-DESIGN RULES FOR GAS-ASSISTED INJECTION MOLDING PROCESS – written by Effinno

Thermoplastics Injection Molding Condition Setup Procedure (the 2nd round, Y2021) – April 28, 2021
Post：2023/01/07

Organized by PIDC (Plastics Industry Development Center) Taiwan, Effinno Technologies delivered the

Cooling Design and Temperature Control of Injection Mold – March 26, 2021
Post：2023/01/07

Organized by SPE (Society of Plastics Engineers) Taiwan and supported by PIDC (Plastics Industry Dev
Thermoplastics Injection Molding Condition Setup Procedure – January 13, 2021
Post：2023/01/07

Organized by PIDC (Plastics Industry Development Center) Taiwan, Effinno Technologies delivered the

Interpreting Injection Molding Process from Polymer Perspective – August 7, 2020
Post：2023/01/07

Organized by SPE (Society of Plastics Engineers) Taiwan and supported by PIDC (Plastics Industry Dev
Training Course - Scientific Approach to Injection Molding Process and Operation – June 2020
Post：2023/01/07

Organized by TECA (Taiwan Electronic Connection Association), Effinno Technologies delivered the int
Injection Molding Engineering System Optimization by Taguchi DOE – November 18, 2019
Post：2023/01/07

Invited by the Department of Mold and Die Engineering of National Kaohsiung University of Science an
  • 1
    •  
  • 2
    •  
  • 3
    •  
TOP